EcoshieldTM
Primary and Final Treatment* Systems for Photo Chemical Waste
MS100 Automatic Metering Station
MS75 Passive Economy Metering Station EcoshieldTM Photo Chemical Waste
Filters
MR200 Small Photo Chemical Waste Filtration System Replacement Cartridges for MR200 Effluent
Sample Box, ESB
The EcoWizardTM Wizard RocksTM
*Primary Treatment
for Black & White and Bleach/Fix
*Final Treatment for Black &
White, E6, and C-41 photochemical fixer with CSRS recirculating Units.

- MS100
Metering Station-Collection Tank
- with automatic control system and metering pump.
- Large 15 gallon (57 L) holding capacity
- Processing capacity: 19 to 50 gal (72 to189 L) daily.

|
FEATURES:
- Fully automatic operation
- Large funnel for manual fluid entry
- Hour meter to determine volume of solution pumped
- Can be easily connected to multiple processors
- Adjustable pump rate (50 -250 ml/mn) 10 - 50 gal/day. Simple to
adjust (Pump adjustments are not made through control panel which invites unwanted
changes)
- Holding Capacity; Because of the larger holding capacity the CSRS
unit can readily handle the volume from multiple processors. The additional holding
capacity also allows for the periodic processor maintenance where all the fixer chemistry
is dumped at one time
- Manual Fill Port The CSRS units have a large manual fill port that
allows solution to be manually poured in as well as inspection of the tank
- Reliable long lasting Pumps; Bellows Metering Pumps with EDPT
seals
- Easy to Install; Connect the hoses, plug in the unit, fill the
system with water or fixer to prime system.
- 115 V 60 Hz
- 2 Amps.
- Dimensions (H x Dia) 30.5 x 14 (77x36 cm)
- Weight: 19 lbs (8.6 kg). Dimensional Weight (air) 64 kgs.
The New MS200-10 and MS200-20 Metering Station The Next
generation in Metering Solutions!
|
Return to Top of Page
MS75 MeteringStation (Passive) holding tank with non-clog filter
- Gravity feed only.
- Must be placed below
processor tank, and above metallic exchange filters.
-

|
FEATURES:
- Economy system
- Gravity Feed
- Adjustable metering valve
- Large manual fluid entry port
- Replaceable filter to prevent clogging in metering valve.
- Holding Capacity: 5 gal/19 L.
- Dimensions: (Lx Dia) 19 x 12.5 (48x32 cm)
- Weight: 7 lbs.(3kg).
|
- Ecoshield Photo Chemical Waste Filters
Ecoshield Photo Chemical Waste Filters
supplied with connection fittings and installation instructions.
|
|

|
MR55 |
MR65 |
MR95 |
Small Photo/Chemical Metallic
Replacement Filter
Small Volume: Treats up to 150 gal/568 L* Dimensions (H x Dia)
15 x 12.5 (38 x 32 cm) Weight: 13 lbs. (6 kg). |
Medium Photo/Chemical
Metallic Replacement Filter
Medium Volume: Treats up to 300 gal/1136 L* Dimensions (H x Dia)
19 x 12.5 (48 x 32 cm) Weight: 19 lbs. (8.6 kg). |
Jumbo Photo/Chemical Metallic
Replacement Filter
High Volume: Treats up to 900 gal/3407 L* Dimensions (H x Dia)
22 x 17 (56 x 43 cm) Weight: 36 lbs. (16.3 kg). |
*Processing capacity based on incoming silver concentration.
FEATURES:
- Priced Economically
- Tried and proven design concept
- Inspection Port
- Resists clogging, back-up and channeling
- Low profile design with proper iron density insures systems can be
gravity fed when connected in series.
- Disposable Plastic Containers
- Removable, resealable lids
- Optional External "Safety" By-Pass to prevent processor
backup
- Capable of achieving <1ppm through two filters in series.
- As Primary System, compatible with Black and White, Bleach/Fix,
E6, and C-41 fixers.
Return to Top of Page

- MR 200 Small Photo Chemical Waste Filtration System
- Economical primary recovery system with 2 Replaceable Metallic
Exchange Cores (Treats up to 25 gal/95 L per month. Maximum recovery period: 6 months.
Processing capacity: (Based on incoming silver) 75 to 180 gal/284 to 681 L.


- DESCRIPTION: Designed
to remove silver waste from photochemistry. Silver bearing fixer solution passes by
gravity flow from the processor overflow drain tube into first the primary and then the
secondary chamber of the MR200 where effluent is desilvered prior to passing to the drain
or the Effluent Sample Box (ESB). The MR200 can reduce silver concentration from
photographic fixer solutions to less than 5 ppm. Laboratory results have consistently
indicated that the MR200 will meet the Environmental Requirements providing the units are
installed properly in relation to the flow rate, volume processed and total time used.The
MR200 has no electrical or mechanical parts. It works on the chemical reaction of two
dissimilar metals acting together in an acid solution to create an electrical charge
(galvanic cell). The silver is plated onto mesh when both metals are present in the acidic
fixer solution. Some of the silver will also form as a sludge which falls to the bottom of
the collection bag.
-
- Dimensions (L/W/D) 19 x 13 x 15. (48x33x38 cm)
- Weight: 35 lb s (15.9kg).
- 7101AA Replacement Cartridge Set for MR200.
-
- Two (2) 4lb/1.8kg cores w/
filter bags. Maximum recovery period: 6 months.
- Processing capacity: (Based on incoming silver) 75 to 180 gal/284
to 681 L.
- Weight: 10 lbs. (4.5 kg).

ESB Neutralization and Sampling Tank
with lab sample bottle

|
FEATURES:
- Economically priced!
- No change outs required!
- Rugged Chemical resistant molded cabinet
- Inner vapor lid
- Neutralizes pH to acceptable standards
- Ph shift of effluent allows precipitation of iron hydroxide as a
sludge thus reducing buildup in drains
- Drain cock for periodic (annual) maintenance. CSRS recommends that
contents (sludge) from the ESB is dumped into the top of a spent metallic exchange filter
for hauling and refining
- Provides convenient sample point for silver testing
- Can be connected to two processors.
- Dimensions (L/W/H): 14 .75 x 14.75 x 14 (38x38x36 cm)
- Weight: 15 lbs (6.8 kg).
- Holding Capacity: 5 gal/19 L.
|
Return to Top of Page
Final Treatment, Inspection, and
Sampling Station.
Can be used as a primary or secondary silver recovery unit.
Co-mingles and neutralizes developer, fixer, and washwater for safe discharge to the
drain. Provides final filtration of silver prior to discharge to the drain. Provides
accurate sample for effluent analysis.
|
|

- Docks neatly behind CSRS floor-mounted SilverWizardTM J-Series Recirculating
Silver Recovery Units (SRU)
|
FEATURES:
- Provides final filtration of silver prior to discharge to drain
- Co-mingles and neutralizes developer, fixer, and washwater for
safe discharge to the drain
- User-friendly inspection port and sample valve for analysis
purposes
- Durable, chemical resistant molded polyethylene container and
cover
- Convenient, neat, ergonomically pleasing design
- Provides secondary containment
- Includes "magical" Wizard RocksTM that buffer the pH,
neutralize the solution, and promote precipitation of the disolved solids within the
collection chamber.
- Inspection Window shows condition of external (visual) safety
bypass on CSRS MR55 or MR65 EcoshieldTM filters
- Gravity Fed
- No moving parts
- Can be used as primary or secondary silver recovery unit
- Three month service cycle, depending on incoming silver and volume
- Designed to interface with inline silver recovery units
- Docks neatly behind CSRS floor-mounted SilverWizardTM J-Series recirculating
silver recovery units (SRU)
- Optional Leak Detector
Dimensions: (HxDxW)
27x17x22.5 in. (52.07x86.36x22.2 cm.
Weight: Holding Capacity: |
Wizard
RocksTM
Replace Annually
|
Features:
- Buffers the pH
- Neutralizes the solution
- Promotes precipitation of the disolved solids within the
collection chamber.
Weight: |
|
|
Return to Top of Page
- Other Products
- RECIRCULATING SILVER
RECOVERY SYSTEMS
- CS J Series Models J1t - J4t,
CS Model L1, Optional Pump Kit for L1, L1 Spill Tray
- Floor Stands
- DPU, Dual Processor
Connection Unit.
- WASHWATER WIZARDTM Washwater
Recirculating Equipment, Resin Cartridges
- ACCESSORIES
- Secondary Containment Trays,
Silver Test Kits
- Packages

Voice: 562-940-0990
Fax: 760-323-1788
- This site designed and maintained by CSRS. Comments and suggestions are welcome!
Content copyright © 1996, 1997, 1998, 1999, 2000, 2006.
www.csrs.com All rights reserved, worldwide.
Last revised: 8/10/06
